Radio Systems CT-2002 Betriebsanleitung PDF herunterladen (Seite 7)

Radio Systems, Inc. CT-2002 Manual

Page 6

Slaved Displays

To Utilize as a Slaved Clock Display (CT-2002 Display units only):

1. Consult page 10 for setup functions to select either RS or SMPTE sync format.

2. Provide serial data to the unit. Choices of serail data are SMPTE time code

and Radio Systems Time-of-Day data from CT-2002 GPS or CT-2002 Master

units. In addition a CT-2002 display unit can be used to provide Time-of-Day

and Timer data in the Radio Systems format. To connect to slave Time-of-Day

displays only, wire only the serial data input terminals in parallel (use either

the terminal strip or RJ-45 connectors — see the connections diagram on page

21).

3. The “SYNC” front panel LED will light and the time-of-day will immediately

conform to the master unit readout.

4. Time-of-Day setting is no longer available on this slave display. Time-of-Day

setting must be made to the unit providing the serial Time-of-Day data.

5. If the data link is lost, the clock will revert to stand-alone local operation and

the “data” lamp will extinguish.

6. Local timer functions continue to be available as described on the preceding

page.

7. The hour may be offset from the master time-of-day via the infra-red remote

control. See IR remote control operation.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Keine Kommentare

Radio Systems CT-2002 Betriebsanleitung Seite 7