Radio Systems CT-2002 Betriebsanleitung PDF herunterladen (Seite 8)

Radio Systems, Inc. CT2002 Manual

Page 7

To Utilize as a Slaved Timer Display as well as a slaved clock dis-

play. (CT-2002 Display units only):

1. Consult page 22 for Setup function programming, and choose selection

3 option “RS2” for slave timer operation.

2. Provide serial data from any CT-2002 display unit whose timer display you

want to slave. Connect the serial data output terminals of the up-stream

CT-2002 Display to the serial data input terminals of the slave display. Use

either terminal strip or RJ-45 connectivity (consult wiring diagram on page

22.)

3. Place the slave display in the clock mode and confirm that the “SYNC” front

panel LED on the slave display is lit and theat the slave displays shows the

Time-of-Day from the up-stream unit.

4. In the “Clock” mode, the time-of-day on the slave display will now conform

to the up-stream stand alone display (regardless of what mode is being

displayed on the stand-alone upstream display.)

5. Place the slave display in the timer mode and press the “MEM 6” button on

the IR remote control. Confirm that the sync LED on the slave lights and that

the slave display shows the timer data from the up-stream display unit.

6. To return the slave display to none-slaving timer (stand-alone) functionality,

press the “RESET” button on the IR remote control with the slave display in

the timer mode. The “SYNC” LED will extinguish and the timer display will

reset to 00:00, allowing local (IR and parallel) timer control.

7. To return to slave timer operation, push the “MEM 6” button on the IR

remote control with the slave display in the timer mode. The “SYNC” LED

will (re)illuminate and the display will conform to the up-stream stand-alone

timer display.

8. Additional timers “downstream” from this slave timer may be wired to slave

to this timers display, or function as Time-of-Day displays and independent

stand-alone timer displays. Consult the wiring diagram on page 22 for

specific wiring configurations.

Wired Remote Control

All front panel controls are available on the rear barrier strip connector.

Contacts are momentary / pull-to-ground.

See attached wiring diagram for connections - page 19.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Keine Kommentare

Radio Systems CT-2002 Betriebsanleitung Seite 8