Radio Systems CT-2002 Betriebsanleitung PDF herunterladen (Seite 13)

Radio Systems, Inc. CT-2002 Manual

Page 12

RESETSTOP

START

CLOCK TIMER

CLOCK SET

PROGRAM

1

2

3

4

5

6

78

9

0

MEM 1 MEM 2 MEM 3

MEM 4 MEM 5 MEM 6

Storing Down Times

1. Press the Timer Button.

The Timer Led will illuminate.

2. Using the numeric keypad, enter a down

time. The Set Led and Down Led will illumi-

nate. Hours may be from 00 to 99, minutes

from 00 to 59, and seconds from 00 to 59.

Erroneous entries can be overwritten or the

Reset button can be used to zero the display.

3. Press one of the Store Buttons. If the time

entered was valid, the display will momen-

tarily flash, the Set Led will extinguish and

the down time will be stored. In addition, the

entered down time will remain on the display

and the Down Led will remain illuminated.

However, an invalid time (such as 12:60:00)

will be cleared when a Store Button is

pressed. In addition, the CT-2002 will return

to the Up Timer Mode.

4. Repeat steps 2 and 3 as desired.

Recalling Stored Down Times

1. Press the Timer Button.

The Timer Led will illuminate.

2. Press one of the Store Buttons.

3. The stored down time will appear on the

display. The Down Led will illuminate.

4. Press the Start Button to begin down timing.

5. Press the Stop Button to stop down timing.

6. Press the Start Button to resume down timing.

7. Press the Reset Button once to recall the

selected down time. Repeat steps 3 through 6

as desired.

8. Press the Reset Button two times to exit the

down mode (return to up timing mode) and

clear the display

Note: Stored Down-Time 1 can be recalled

remotely via parallel remote control wiring.

See illustration page 19.

Push to display

Time-of-Day

Push to freeze

Timer Display

When Up-Timing:

Push once to reset timing to 00:00

(Continues to run if reset from Stop)

(Holds if reset from Stop)

When Down-Timing:

Push once to redisplay down time.

Push again to return display to 00:00

and Up-Time mode.

In Clock Mode:

Starts display running from

Time-of-Day set mode

In Timer Mode:

Starts display running from

Up or Down Timer display

Push for Timer Mode

Push to set Time-of-Day

Enter via numeric keypad.

Push start.

Push to set Internal Programming fea-

tures (see setup functions on page 10).

Program functions via

numeric keypad.

Push Timer or Clock to exit

in that mode

To set down time

Enter time via numeric keypad.

Push start to begin.

Push reset to recall downtime.

Push reset 2x to exit.

CT-2002 InfraRed Remote Control

MEM 6 is retasked to switch the

timer between slave and local

modes when using associated dis-

play as a remote timer. See page 7.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare